Learn how to regime new vital Fob for 2008-2016 Chrysler Town&Country, 2008-2020 Dodge grand Caravan and other associated minivans using Appcar software.

You are watching: 2014 chrysler town and country key fob programming

✔️ You have the right to program new an essential Fob or re-program previously programmed on this vehicle vital Fob.❌ Programming a used vital Fob, previously programmed for another vehicle, calls for unlocking by erasing the internal vital memory v a one-of-a-kind locksmith tool.

This guide applies to the following cars:

Chrysler city & Country 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016Chrysler grand Voyager 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016Dodge grand Caravan 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020Lancia Voyager 2011, 2012, 2013, 2014, 2015Volkswagen Routan 2009, 2010, 2011, 2012, 2013, 2014RAM Cargo VAN 2012, 2013, 2014, 20151️⃣ Insert the new vital Fob in the ignition and also turn to the operation position.

If the auto is equipped with Keyless Enter-N-Go, remove the Engine START/STOP button. Climate insert the new an essential Fob in the ignition and also turn to the operation position.EVIC will screen message: ‘Key not Programmed’.

*

2️⃣ develop a connection with the vehicle, and run ‘Read pin Code’ Routine.

You can discover it in Diagnostic -> WCM -> Routines. The pin code will be needed when programming the new vital Fob.

*

👉 exactly how to review PIN Code

3️⃣ run ‘Program Ignition keys or key FOBs’ routine

*

On the an initial step you will view the number of currently programmed keys. Usually have the right to be a best of 8.

*

In the 2nd step, you have to enter the 4-digit pin code.

*

Then the ignition module will start the vital Fob programming procedure. It might take numerous seconds.

See more: Nankang At-5 Conqueror A/T

*

After a when you must see the programming result and the number of currently programmed vital fobs – one more than prior to 👌

*

4️⃣ If the auto is equipped through a Keyless Go

and the programmed an essential supports this role (cheap replacements usually execute not support it) – 👉 PEM Replace Routine have to be run. Girlfriend can discover it in Diagnostic -> PEM -> Routines.

⚠️ Common causes when the ignition module is unable to program the key:

– wrong an essential fob type – similar looking an essential fobs room not interchangeable,– the crucial fob was already programmed to another vehicle,– the maximum variety of programmed keys has actually been exceeded,– too low or too high key fob battery voltage – need to be roughly 3.3 Volts